Want to do your bit to help save the world?
No real need to have the CPU in your home Linux box burning away flat out! This will idle the CPU at its lowest supported speed, and adjust the clock rate as needed depending on the load. This example is for an P4 based CPU (in my case a Celeron D 2.8GHz) using p4_clockmod
Some of the other common drivers (or modules) are :
AMD K6 processors : powernow_k6
AMD K7 processors (Athlon, Duron, Sempron 32 bits) : powernow_k7
AMD K8 processors (Athlon 64, Turion 64, Sempron 64, Opteron 64) : powernow_k8
Pentium 4, Celeron D, Pentium D, Celeron M : p4_clockmod
Pentium M, Core Duo, Core 2 Duo : speedstep_centrino
There are of course other CPU frequency drivers. In doubt, you can use the generic driver : acpi_cpufreq
Right, down to business (replace p4_clockmod with the driver for your CPU):
apt-get install cpufrequtils sysfsutils
modprobe p4_clockmod
modprobe cpufreq_ondemand
echo ondemand | tee /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
Verify whats happening:
cpufreq-info
cpufrequtils 002: cpufreq-info (C) Dominik Brodowski 2004-2006
Report errors and bugs to linux@brodo.de, please.
analyzing CPU 0:
driver: p4-clockmod
CPUs which need to switch frequency at the same time: 0
hardware limits: 350 MHz – 2.80 GHz
available frequency steps: 350 MHz, 700 MHz, 1.05 GHz, 1.40 GHz, 1.75 GHz, 2.10 GHz, 2.45 GHz, 2.80 GHz
available cpufreq governors: ondemand, performance
current policy: frequency should be within 350 MHz and 2.80 GHz.
The governor “ondemand” may decide which speed to use
within this range.
current CPU frequency is 350 MHz.
Save config/apply at startup:
echo p4_clockmod | tee -a /etc/modules
echo cpufreq_ondemand | tee -a /etc/modules
echo devices/system/cpu/cpu0/cpufreq/scaling_governor = ondemand | tee -a /etc/sysfs.conf
Reboot and run cpufreq-info again to verify. All done! Last-Modified: 2008-12-11 21:19:35